Used for bed frames, bicycle racks, drawer slide and motor mounts.

Black die-cast supports w/wood handle. Mounting posts come finished in black colored paint and the wooden pull handle comes finished in a clear finish. Can be installed on doors with mounting hole centers ranging from 6-1/2 to 6-5/8 in center-2-center. Surface-mounted. Features a sturdy metal backer support behind the wood. Note: Color of wood may vary per shipment.

The OOK? hardwall hanger is a favorite for hanging light projects on surfaces such as brick or concrete where regular nails are not adequate.

Prime-Line 3/4 in x 5/16 in plastic corner for window screen panels are designed to fit into square-cut ends of 5/16 aluminum screen frame material to repair or construct new aluminum-framed screens. Square-cut assembly eliminates the need for miter cutting providing for an easier frame construction by the homeowner.

Fluted edging protects and improves the appearance of stair edges. 1/8 in H.

When subjected to 312 hrs of salt fog spray testing (BHMA A138.18), zinc-plated hardware showed severe corrosion while hardware with Weather Guard? protection withstood these harsh conditions with very little deterioration.

A premium quality back support belt with an 8 in wide, heavy-duty back panel and internal stays for extra support.

PRO-SOURCE FRAME HANGER ZINC

Door and window high density, self-adhesive weatherproofing tape. Tough sponge rubber ensures long-lasting seal. Can be trimmed to fit application.

Medium-duty, precision slides for box drawer or pedestal file drawers up to 24 in wide. For frame and frameless construction. May be used horizontal position with a reduced load rating of 30 lb. Height of 1-13/16 in, required clearance of 1/2 in plus 1/32 in minus 0 each side. Features telescoping, full extension on precision steel ball bearings. 32 mm hole pattern with direct access mounting. Lever disconnect for easy drawer removal. Ball retainer latch and ramps, for easy drawer insertion. Drawer adjustment without removal. Flexible mounting tabs self-adjust to side clearance. Metal ball retainer holds 3 bearings per inch of race for smooth and quiet motion. Polymer stop cushions. Non-handed. Packaged with screws and installation instructions.

HOOK BOLT STEEL 5/8X12IN ZINC
Designed for use as a replacement part with Model No. 292 bolt hook and strap hinges, or for new installations with Model No. 294 hinge straps only. Adjusts to correct gate sag. Includes 2 washers and 2 nuts per hinge. Full thread hook is bolted through the post and firmly secured with standard size nuts and washers on each side